Mgmt Vlan - Siemens SCALANCE XC-200 Configuration Manual

Further notes
With the interface range command, you can put several interfaces or VLANs together to
be able to configure them together.
6.1.2.4

mgmt vlan

Description
With this command, you change the agent VLAN ID. You can only use VLANs that have already
been configured.
Note
Changing the agent VLAN ID
If the configuration PC is connected directly to the device via Ethernet and you change the
agent VLAN ID, the device is no longer reachable via Ethernet following the change.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mgmt vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameter
vlan-id
Result
The Agent VLAN ID has been changed.
Further notes
You show the configuration of the IP interfaces with the show ip interface command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Number of the addressed VLAN
Network structures
6.1 VLAN
Range of values
1 ... 4094
175