Commands In The Global Configuration Mode (Vlan Bridge); Mac-Address-Table Static Unicast - Siemens SCALANCE XC-200 Configuration Manual

For information on names of interfaces and addresses, refer to the section "Addresses and
interface names (Page 36)".
Result
The unicast blocking settings for ports are displayed.
8.5.2

Commands in the global configuration mode (VLAN bridge)

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
8.5.2.1

mac-address-table static unicast

Description
With this command, you generate a static unicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table static unicast <aa:aa:aa:aa:aa:aa>
vlan <vlan-id(1-4094)>
interface ([<interface-type> <interface-id>]
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
vlan
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
[<interface-type> <0/a-b, 0/c,...>]
[port-channel <interface-list>])
Description
MAC address of the interface
Keyword for a VLAN connection
Layer 2 management protocols
8.5 Unicast
Range of values / note
-
-
413