Sender Mail-Address - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.6 SMTP client
cli(config-events)#
Syntax
Call up the command with the following parameters:
no smtp-server ipv4 <ucast_addr>
The parameter has the following meaning:
Parameter
ipv4
ucast_addr
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The SMTP server entry is deleted.
Further notes
You configure an e-mail server entry with the smtp-server command.
7.6.2.3

sender mail-address

Description
With this command, you configure the e-mail name of the sender.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
sender mail-address <mail-address>
The parameter has the following meaning:
Parameter
mail-address
354
Description
Keyword for an IPv4 address
Value for an IPv4 address
Description
Email name of the sender
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values
-
Enter a valid IPv4 address.
Range of values / note
max. 100 characters
Configuration Manual, 07/2017, C79000-G8976-C361-06