Poe; The "Show" Commands; Show Poe Status - Siemens SCALANCE XC-200 Configuration Manual

Configuration

3.5 PoE

3.5 PoE
3.5.1

The "show" commands

This section describes commands with which you display various settings.
3.5.1.1

show poe status

Description
This command shows specific information for all or for a selected PoE interface (PoE: Power
over Ethernet).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show poe status [interface <interface-type> <interface-id>]
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
If you use the command without setting parameters, information about all PoE interfaces is
displayed.
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The information for the selected PoE interface is displayed.
110
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Enter a valid interface.
Configuration Manual, 07/2017, C79000-G8976-C361-06