No Switchport Acceptable-Frame-Type - Siemens SCALANCE XC-200 Configuration Manual

Result
The setting is enabled.
Further notes
You can reset the setting to the default with the no switchport acceptable-frame-
type command.
You can display the status of this function and other information with the show vlan port
config command.
6.1.3.4

no switchport acceptable-frame-type

Description
With this command, you reset the setting for the types of frames accepted by the interface to
the default value.
The default value is all.
The interface accepts tagged and untagged frames.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport acceptable-frame-type
Result
The setting is reset to the default value.
Further notes
You configure the setting with the switchport acceptable-frame-type command.
You can display the status of this function and other information with the show vlan port
configcommand.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Network structures
6.1 VLAN
181