Sntp Client; The "Show" Commands; Show Sntp Broadcast-Mode Status; Show Sntp Unicast-Mode Status - Siemens SCALANCE XC-200 Configuration Manual

System time

5.3 SNTP client

5.3 SNTP client
This section describes commands relevant for configuration of the SNTP client.
5.3.1

The "show" commands

This section describes commands with which you display various settings.
5.3.1.1

show sntp broadcast-mode status

Description
This command shows the current configuration of the broadcast mode of SNTP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show sntp broadcast-mode status
Result
The current SNTP broadcast configuration is displayed.
5.3.1.2

show sntp unicast-mode status

Description
This command shows the current configuration of the unicast mode of SNTP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
154
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06