Commands In The Global Configuration Mode; Spanning-Tree - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.3 Spanning Tree
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
clear spanning-tree counters
Result
The spanning tree counters are reset.
6.3.4

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
6.3.4.1

spanning-tree

Description
The Spanning Tree Protocol is used to monitor a LAN for redundant connections. These are
blocked and reactivated when necessary if there are changes to the network topology.
With this command, you enable the spanning tree function.
Requirement
● The ring redundancy is disabled.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
spanning-tree
228
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06