Igmp Querier; Commands In The Global Configuration Mode; Ip Igmp Snooping Querier - Siemens SCALANCE XC-200 Configuration Manual

8.3

IGMP querier

This section describes the commands for the query functionality of the Internet Group
Management Protocol (IGMP).
8.3.1

Commands in the Global Configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
8.3.1.1

ip igmp snooping querier

Description
With this command, you configure the IGMP snooping switch as querier.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip igmp snooping querier
As default the function is "disabled".
Result
The IGMP snooping switch is configured as querier.
Further notes
You delete the setting with the no ip igmp snooping querier command.
You can display the status of this function and other information with the show ip igmp
snooping command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Layer 2 management protocols
8.3 IGMP querier
387