Poe Pse Usage; No Poe Pse Usage - Siemens SCALANCE XC-200 Configuration Manual

Configuration
3.5 PoE
3.5.2.1

poe pse usage

Description
With this command, you set a value (as a percentage) for the "Usage Threshold" parameter.
This specifies how many percent of the maximum power the connected devices will use. As
soon as the power being used by the end devices exceeds this percentage, an event is
triggered. An event is also entered in the log. You display the entries of the log with the
command show logbook. You will find more information on this command in the section
"show logbook (Page 546)".
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
poe pse <integer (1-4)> usage <integer (1-100)>
The parameters have the following meaning:
Parameter
integer
integer
Result
The value for "Usage Threshold" is configured.
3.5.2.2

no poe pse usage

Description
With this command, you reset the parameter "Usage Threshold" to the default value.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
112
Description
Number of the PSE
Value for "Usage Threshold" as a per‐
centage.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
1 ... 4
1 ... 100
Default: 80%
Configuration Manual, 07/2017, C79000-G8976-C361-06