Show Unicast-Block Config; Commands In The Global Configuration Mode (Transparent Bridge) - Siemens SCALANCE XC-200 Configuration Manual

For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The static unicast MAC addresses are displayed.
8.5.3.3

show unicast-block config

Description
This command shows the unicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show unicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of interfaces and addresses, refer to the section "Addresses and
interface names (Page 36)".
Result
The unicast blocking settings for ports are displayed.
8.5.4

Commands in the global configuration mode (Transparent Bridge)

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for a port description
Type or speed of the interface
Module no. and port no. of the interface
Layer 2 management protocols
8.5 Unicast
Range of values / note
-
Enter a valid interface
417