Show Interfaces - Siemens SCALANCE XC-200 Configuration Manual

Configuration
3.1 System
3.1.1.8

show interfaces

Description
This command shows the status and the configuration of one, several or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show interfaces
The parameters have the following meaning:
Parameter
interface-type
interface-id
description
stormcontrol
flowcontrol
status
vlan
vlan-id
port-channel
port-channel-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the status and configuration of all
available interfaces will be displayed.
52
[{
[<interface-type><interface-id>]
[{description|stormcontrol|flowcontrol|status}]
|
{vlan<vlan-id(1-4094)>}
|
port-channel<port-channel-id(1-8)>
}]
Description
Type or speed of the interface
Module no. and port no. of the interface
Shows the description of the interface
Shows the storm control settings
Shows the flow control settings
Shows the status of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a port channel connection
Number of the addressed port channel
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
Enter a valid interface.
-
-
-
-
-
1 ... 4094
-
1 ... 8
Configuration Manual, 07/2017, C79000-G8976-C361-06