Dot1X Port-Control - Siemens SCALANCE XC-200 Configuration Manual

Syntax
Call up the command with the following parameters:
set dot1x mac-auth mac-addr count <num-of-addresses (1-100)>
The parameter has the following meaning:
Parameter
num-of-addresses
Result
The maximum number of devices for the port has been specified.
Further notes
You display this setting and other information with the show dot1x command.
11.5.3.13

dot1x port-control

Description
With this command, you configure port control parameter of the authenticator.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x port-control {auto|force-authorized|force-unauthorized}
The parameters have the following meaning:
Parameter
auto
force-authorized
force-
unauthorized
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Maximum number of devices
Description
Authentication according to IEEE
802.1x is enabled for the interface.
The data traffic via the interface is per‐
mitted or blocked depending on the au‐
thentication result.
data traffic via the interface is permitted
without restrictions
data traffic via the interface is blocked
Security and authentication
11.5 Port Based Network Access Control
Range of values / note
1 ... 100
Range of values / note
-
Default: force-authorized en‐
abled
-
537