The "Show" Commands (Transparent Bridge); Show Dot1D Mac-Address-Table - Siemens SCALANCE XC-200 Configuration Manual

Layer 2 management protocols
8.6 Multicast
The parameters have the following meaning:
Parameter
aa:aa:aa:aa
:aa:aa
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The "static multicast" function is disabled.
8.6.3

The "show" commands (Transparent Bridge)

This section describes commands with which you display various settings.
8.6.3.1

show dot1d mac-address-table

Description
This command shows the table with the static and dynamic unicast entries and the dynamic
multicast entries.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show dot1d mac-address-table [address <aa:aa:aa:aa:aa:aa>]
The parameters have the following meaning:
Parameter
address
aa:aa:aa:aa:aa:aa
426
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
[{interface <interface-type> <interface-id>}]
Description
Keyword for a MAC address
MAC address
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
-
1 ... 4094
Range of values/note
-
Specify a valid MAC ad‐
dress.
Configuration Manual, 07/2017, C79000-G8976-C361-06