Network structures
6.1 VLAN
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no priority-enable
Result
The priority of the VLAN is disabled.
Further notes
You enable the priority with the priority-enable command.
You change the priority with the prioritycommand.
You reset the priority to the default value with the no priority command.
You display the current priority with the show vlan command.
6.1.4.9
private-vlan
Description
With this command you define a VLAN as a private VLAN and specify the PVLAN type.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
private-vlan { primary | isolated | community }
200
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06