Commands In The Global Configuration Mode; Arp Timeout - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.9 ARP
Result
The IP ARP table is displayed.
7.9.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
7.9.2.1

arp timeout

Description
With this command, you configure the timeout setting of the ARP cache.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
arp timeout <seconds(30-86400)>
The parameter has the following meaning:
Parameter
seconds
Result
The setting for the timeout setting of the ARP cache is configured.
Further notes
You can reset the timeout setting to the default with the no arp timeout command.
364
Description
Value for the timeout in seconds
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Range of values / note
30 ... 86400
Default: 300