No Radius-Server - Siemens SCALANCE XC-200 Configuration Manual

11.2.2.4

no radius-server

Description
With this command, you delete a RADIUS server entry on the client.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no radius-server ipv4 <ipv4-address> [primary]
The parameters have the following meaning:
Parameter
ipv4-address
primary
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 36)".
Result
The entry for a connection between the RADIUS client and a server or the identification as
primary server is deleted.
Further notes
You configure the connection of a RADIUS client to a server with the radius-server
command.
You show the configuration of a RADIUS server on the client with the show radius
server command.
You show the statistical information of this function with the show radius statistics
command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
IPv4 Internet address of the Syslog
server
Identifies the RADIUS server as primary
server
Security and authentication
11.2 RADIUS client
Range of values / note
Format: 0.0.0.0
-
511