No Ports - Siemens SCALANCE XC-200 Configuration Manual

After you have created an IPv4 address band, all ports are selected that are currently located
in the corresponding VLAN. If you add ports to the VLAN later, these ports are not automatically
enabled.
With address assignments via a relay agent, you cannot restrict the ports.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
ports [<interface-type> <0/a-b, 0/c, ...>] [<interface-type> <0/a-b,
0/c, ...>]
The parameters have the following meaning:
Parameter
interface-type
0/a-b,0/c,...
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The selected ports will be enabled. Before the IPv4 address band can be used, it still needs
to be activated.
Further notes
You disable the ports with the no ports command.
You display the setting with the show ip dhcp-server pools command.
You enable the IPv4 address band with the pool-enable command.
7.3.3.9

no ports

Description
With this command you disable the ports via which the IPv4 addresses of an address band in
the local subnet are assigned.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Type or speed of the interface
Port no. of the interface
Network protocols
7.3 DHCP server
Range of values / note
Enter a valid interface
301