Show Dot1D Mac-Address-Table Static Unicast - Siemens SCALANCE XC-200 Configuration Manual

Layer 2 management protocols
8.5 Unicast
The parameters have the following meaning:
Parameter
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries are displayed.
8.5.3.2

show dot1d mac-address-table static unicast

Description
This command shows the table with the static unicast MAC addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show dot1d mac-address-table static unicast [address
<aa:aa:aa:aa:aa:aa>]
The parameters have the following meaning:
Parameter
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
416
Description
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
[{interface <interface-type> <interface-id>}]
Description
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values/note
-
Specify a valid MAC ad‐
dress.
-
Enter a valid interface.
Range of values / note
-
-
-
Enter a valid interface
Configuration Manual, 07/2017, C79000-G8976-C361-06