Spanning-Tree Mst Max-Hops - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.3 Spanning Tree
Result
The "root bridge" function is disabled.
Further notes
You enable the root bridge function with the spanning-tree mst instance-id root
command.
You display this setting and other information with the commands that start with show
spanning tree ....
6.3.4.8

spanning-tree mst max-hops

Description
With this command, you configure the maximum number of nodes (hops) that a path can run
through in an MST.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree mst max-hops <value(6-40)>
The parameter has the following meaning:
Parameter
value
Result
The setting for the maximum number of hops is configured.
Further notes
You can reset the setting for the maximum number of nodes to the default with the no
spanning-tree mst max-hops command.
You display this setting and other information with the show spanning tree mst
configuration command.
234
Description
Maximum number of hops that a path
can run through in an MST
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
6 ... 40
Default: 20
Configuration Manual, 07/2017, C79000-G8976-C361-06