Ip Dhcp Relay Common-Agent-Address-Interface - Siemens SCALANCE XC-200 Configuration Manual

Result
The relay agent uses the address of the receiving port in DHCP requests.
Further notes
You enable the use of a common agent address with the ip dhcp relay common-agent-
address command.
You define a common agent address with the ip dhcp relay common-agent-address-
interface command.
You reset the common agent address to the default value with the no ip dhcp relay
common-agent-address-interface command.
7.4.2.8

ip dhcp relay common-agent-address-interface

Description
With this command you define the interface whose IP address the relay agent uses as the
source address (giaddr) in DHCP requests.
Requirement
You are in the Global configuration mode.
The command prompt is:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp relay common-agent-address-interface { vlan <vlan-id
(1-4094)> | <interface-type> <interface-id> }
The parameter has the following meaning:
Parameter
vlan
vlan-id
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The IP address of the interface is used as a common agent address.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Slot no. and port no. of the interface
Network protocols
7.4 DHCP Relay
Range of values / note
-
1 ... 4094
Default: vlan1
Enter a valid interface name.
315