Priority - Siemens SCALANCE XC-200 Configuration Manual

Parameter
all
forbidden
name
vlan-name
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The ports are removed from the VLAN configuration.
Further notes
It is possible to remove individual ports from a VLAN configuration without needing to rewrite
the entire configuration.
You display details of the function with the show vlan command.
You configure the setting with the ports command.
6.1.4.5

priority

Description
With this command, you assign a priority to the VLAN. The selected priority is entered in all
incoming frames of this VLAN. The switch sorts the frame into a queue according to this
prioritization .
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
This parameter appears at several points in the command.
● no ports all
This command removes all Member Ports (Tagged Member
- M) from the VLAN.
● no ports untagged all
This command removes all Untagged Member Ports (U) from
the VLAN. Afterwards the ports are Tagged Members (M) in
the VLAN.
● no ports forbidden all
This command removes all Forbidden Ports (F) from the
VLAN.
Keyword for forbidden interfaces or ports
Keyword for the name assignment
Name of the VLAN
Network structures
6.1 VLAN
Range of values / note
-
-
-
max. 32 characters
197