No Ring-Redundancy - Siemens SCALANCE XC-200 Configuration Manual

cli(config)#
Syntax
Call up the command with the following parameters:
ring-redundancy mode {ard | mrpauto | mrpclient | hrpclient |
hrpmanager}
The parameters have the following meaning:
Parameter
ard
mrpauto
mrpclient
hrpclient
hrpmanager
Result
The ring redundancy function is enabled and the redundancy mode is selected.
Further notes
You disable the ring redundancy function with the no ring-redundancy command.
8.4.5.5

no ring-redundancy

Description
With this command, you disable the ring redundancy function on a device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Enables the automatic redundancy mode
(Automatic Redundancy Detection)
Enables the automatic MRP manager
Enables ring redundancy with the MRP pro‐
tocol as client
Enables ring redundancy with the HRP pro‐
tocol as client
Enables ring redundancy with the HRP pro‐
tocol in ring redundancy manager mode
Layer 2 management protocols
8.4 Ring redundancy and standby connection
Range of values / note
● Default setting with PROFINET
variants: enabled
● Default setting with EtherNet/IP
variants: disabled
● Default setting with Industrial
Ethernet variants: disabled
-
-
-
-
397