Commands In The Vlan Configuration Mode (Vlan Bridge); Name - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.1 VLAN
The default value is 1.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport pvid
Result
The setting is reset to the default value.
Further notes
You configure the setting with the switchport pvid command.
You configure the VLAN ID with the switchport access vlan command.
You can display the status of this function and other information with the show vlan port
config command.
6.1.4

Commands in the VLAN configuration mode (VLAN Bridge)

This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the vlan $$$ command to change to this mode.
When doing this, you need to replace the $$$ placeholders with the relevant VLAN ID.
Commands relating to other topics that can be called in the VLAN Configuration mode can be
found in the relevant sections.
● If you exit the VLAN Configuration mode with the exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the end command, you return to the Privileged
EXEC mode.
6.1.4.1

name

Description
With this command, you assign a name to the VLAN.
192
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06