Monitor Session Source - Siemens SCALANCE XC-200 Configuration Manual

Diagnostics
12.5 Port Mirroring
cli(config)#
Syntax
Call up the command with the following parameters:
no monitor session <session-id(1-1)> destination
{interface <interface-type><interface-id>}
The parameters have the following meaning:
Parameter
session-id
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The destination for the mirroring of a port is deleted.
Further notes
You configure the destination for mirroring a port with the monitor session ...
destination command.
You end and delete a session with the no monitor session command.
You display the configuration settings with the show monitor session command.
12.5.2.7

monitor session source

Description
With this command, you configure the source for mirroring a port.
Requirement
● Monitoring is enabled.
● You are in the Global configuration mode.
The command prompt is:
cli(config)#
Syntax
Call up the command for the port to be monitored with the following parameter assignment:
594
Description
Number of the session
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
1
-
Enter a valid interface.
Configuration Manual, 07/2017, C79000-G8976-C361-06