Commands In The Interface Configuration Mode; Ip Address Dhcp - Siemens SCALANCE XC-200 Configuration Manual

Syntax
Call up the command with the following parameters:
ip dhcp client mode {mac|client-id<client-id>|sysname|pnio-name-of-
station}
The parameters have the following meaning:
Parameter
mac
client-id
client-id
sysname
pnio-name-of-
station
Result
The registration mode of the DHCP client is configured.
7.2.3

Commands in the Interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
7.2.3.1

ip address dhcp

Description
With this command, you assign an IP address using DHCP.
Requirement
You are in the VLAN configuration mode.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
The client registers with its MAC ad‐
dress
The client registers with the assigned ID -
Name of the assigned ID
The client registers with the assigned
system name
The client logs in with the PROFINET
name. The name is assigned with the
PST tool.
Network protocols
7.2 DHCP client
Range of values / note
-
max. 32 characters
-
-
285