No Mac-Address-Table Static Unicast - Siemens SCALANCE XC-200 Configuration Manual

Load control
10.2 Static MAC filtering
mac-address-table static unicast <aa:aa:aa:aa:aa:aa>
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
port-channel
interface-list
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The entry in the forwarding database is generated.
Further notes
With the show dot1d mac-address-table static unicast command, you display the
list of configured entries.
With the no mac-address-table static unicast command, you delete an entry.
10.2.2.4

no mac-address-table static unicast

Description
With this command, you delete a static unicast MAC address entry from the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac-address-table static unicast <aa:aa:aa:aa:aa:aa>
468
interface ([<interface-type> <interface-id>]
[<interface-type> <0/a-b, 0/c,...>]
[port-channel <interface-list>])
Description
MAC address of the interface
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a port channel connection
Number of the addressed port channel
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
-
Enter a valid interface.
Enter a valid port channel connec‐
tion.
Configuration Manual, 07/2017, C79000-G8976-C361-06