Cos-Remap - Siemens SCALANCE XC-200 Configuration Manual

10.5.3.6

cos-remap

Description
With this command depending on the priority when receiving a frame, you can change the
priority with which it is sent.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call up the command with the following parameters:
cos-remap interface <interface-type><interface-id> <prio (0-7)>
<remapped prio (0-7)>
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
prio
remapped prio
Result
The send priority has been changed.
Further notes
You reset the send priority to the default value with the no cos-remap command.
You enable the CoS reassignment with the cos-remap-enable command.
You disable the the CoS reassignment with the no cos-remap-enable command.
You display the assignment table for the send priority with the show qos cos-remap
command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Priority with which a frame is received.
Priority with which a frame will be sent
Load control
10.5 Service classes
Range of values / note
-
Enter a valid interface
0 ... 7
0 ... 7
489