The "Show" Commands (Transparent Bridge); Show Dot1D Mac-Address-Table - Siemens SCALANCE XC-200 Configuration Manual

The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The entry is deleted from the forwarding database.
Further notes
With the show mac-address-table static unicast command, you display the list of
configured entries.
With the mac-address-table static unicast command, you create an entry.
8.5.3

The "show" commands (Transparent Bridge)

This section describes commands with which you display various settings.
8.5.3.1

show dot1d mac-address-table

Description
This command shows the table with the static and dynamic unicast entries and the dynamic
multicast entries.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show dot1d mac-address-table [address <aa:aa:aa:aa:aa:aa>]
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
[{interface <interface-type> <interface-id>}]
Layer 2 management protocols
8.5 Unicast
Range of values / note
-
-
1 ... 4094
415