Write Startup-Config; Commands In The Global Configuration Mode - Siemens SCALANCE XC-200 Configuration Manual

Result
The selected configuration settings of the device are displayed.
Passwords are masked as follows: [PASSWORD]
In other "show" commands, passwords are masked as follows: ******
3.4.2

write startup-config

Description
With this command, you save the changes to the configuration in the configuration file.
The use of this command is required in the Trial mode. It can also be used in "auto save mode".
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
*cli# or cli#
Syntax
Call the command without parameter assignment:
write startup-config
Result
The changes are saved in the configuration file.
Use the restart command without parameters to restart the system with this configuration.
Further notes
You enable the auto save function or disable the Trial mode with the auto-save command.
You disable the auto save function or enable the Trial mode with the no auto-save command.
3.4.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Configuration
3.4 Configuration Save & Restore
107