No Switchport Private-Vlan Host-Association - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.1 VLAN
Requirement
● The interface is configured as a host port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport private-vlan host-association <primary-vlanId(1-4094)>
<secondary-vlanId(1-4094)>
The parameters have the following meaning:
Parameter
primary-vlanId
secondary-vlanId
Result
The interface is configured.
Further notes
You delete the configuration with the command.
You display this setting and other information with the commands show vlan port
config, show vlan and show vlan private-vlan.
You configure the interface as a host port with the command.
6.1.3.13

no switchport private-vlan host-association

Description
With this command, you delete the configuration of a host port.
Requirement
● The interface is configured as a host port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
188
Description
VLAN ID of the primary PVLAN
VLAN ID of the secondary PVLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
1 ... 4094
1 ... 4094
Configuration Manual, 07/2017, C79000-G8976-C361-06