Commands In The Global Configuration Mode; Events - Siemens SCALANCE XC-200 Configuration Manual

The parameter has the following meaning:
Parameters
fault-state-id
Result
The message is acknowledged.
12.1.7

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
12.1.7.1

events

Description
With this command, you change to the EVENTS configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
events
Result
You are now in the EVENTS configuration mode.
The command prompt is as follows:
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description Range of values/note
ID of the mes‐ Enter the ID of the message for the "Cold/Warm Start" event.
sage To obtain the ID, use the "show events faults status"
command.
Diagnostics
12.1 Event and fault handling
551