Commands In The Global Configuration Mode (Transparent Bridge); Mac-Address-Table Static Multicast - Siemens SCALANCE XC-200 Configuration Manual

The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The entry is deleted from the forwarding database.
Further notes
With the show mac-address-table static unicast command, you display the list of
configured entries.
With the mac-address-table static unicast command, you create an entry.
10.2.2

Commands in the global configuration mode (Transparent Bridge)

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
10.2.2.1

mac-address-table static multicast

Description
With this command, you generate a static multicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Load control
10.2 Static MAC filtering
Range of values / note
-
-
1 ... 4094
465