No Ring-Redundancy Standby; Commands In The Redundancy Configuration Mode - Siemens SCALANCE XC-200 Configuration Manual

8.4.5.7

no ring-redundancy standby

Description
With this command, you disable the standby function.
Requirement
● HRP is enabled
● You are in the Global configuration mode.
The command prompt is:
cli(config)#
Syntax
Call the command without parameters:
no ring-redundancy standby
Result
The standby function is disabled.
Further notes
You enable the setting with the ring-redundancy standby command.
You can display the status of this function and other information with the show ring-
redundancycommand.
8.4.6

Commands in the redundancy configuration mode

This section describes commands that you can call up in the Redundancy Configuration mode.
In the Global Configuration mode, enter the ring-redundancy configuration command
to change to this mode.
● If you exit the Redundancy Configuration mode with the exit command, you return to the
Global Configuration mode.
● If you exit the Redundancy Configuration mode with the end command, you return to the
Privileged EXEC mode.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Layer 2 management protocols
8.4 Ring redundancy and standby connection
399