Siemens SCALANCE XC-200 Configuration Manual page 444

Layer 3 functions
9.1 NAT
Syntax
Call up the command with the following parameters:
ip nat service <inside local ip> [<inside local port number>]
| snmp | other [<inside global port number>]}
The parameters have the following meaning:
Parameter
inside local ip
inside local port
number
Service
inside global
port number
Protocol
description
Result
The static port translation with a service is configured.
Further notes
You delete a configuration with the no ip nat service command.
You configure static port translations for an interface with a port range with the ip nat
service portrange command.
You display the current configuration with the show ip nat service command.
444
{ auth | dns | ftp | pop3 | pptp | smtp | telnet | http | nntp
[{ tcp | udp | any }] [<description>]
Description
Actual address of the device that
should be reachable from external.
Port that will be assigned to the in‐
side local address.
Service for which the port transla‐
tion is valid.
Port that will be assigned to the in‐
side global address.
Protocol for which the port transla‐
tion is valid.
Description for the port translation -
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
Enter a valid IPv4 address.
If you do not specify any ports, the port
that you assign for the inside
global port number parameter will
be entered.
● auth
● dns
● ftp
● pop3
● pptp
● smtp
● telnet
● http
● nntp
● snmp
● other
If you have selected the other service,
you can enter a port.
If you have selected another service, a
port will be specified.
● tcp
● udp
● any
Configuration Manual, 07/2017, C79000-G8976-C361-06