Agent-Priority; No Agent-Priority - Siemens SCALANCE XC-200 Configuration Manual

10.5.3.1

agent-priority

Description
With this command you specify the priority of agent frames. The switch sorts incoming frames
into a queue according to this prioritization .
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call up the command with the following parameters:
agent-priority <integer (0-7)>
The parameter has the following meaning:
Parameter
integer
Result
The priority of agent frames is configured.
Further notes
You reset the priority of agent frames to the default value with the no agent-priority
command.
You display the current priority of agent frames with the show qos agent-priority
command.
You configure the assignment of the CoS priority to a queue with the cos-map command.
10.5.3.2

no agent-priority

Description
With this command, you reset the priority of agent frames back to the default value.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Value of the priority
Load control
10.5 Service classes
Range of values / note
0 ... 7
485