Snmp Group - Siemens SCALANCE XC-200 Configuration Manual

If the function is disabled, a device-specific SNMP engine ID is generated. To generate the
ID, the agent MAC address of the device is used. You cannot transfer this SNMP user
configuration to other devices.
If you load the configuration of the device on another device, all configured SNMPv3 users are
deleted.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no snmp engineid migrate
Result
The SNMPv3 user migration is disabled.
Further notes
You enable the SNMPv3 user migration with the snmp engineid migrate command.
7.5.2.10

snmp group

Description
With this command, you configure the details of an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp group <GroupName> user <UserName> security-model {v1|v2c|v3}
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
[{volatile|nonvolatile}]
Network protocols
7.5 SNMP
337