Show Mac-Address-Table Dynamic Multicast - Siemens SCALANCE XC-200 Configuration Manual

The parameters have the following meaning:
Parameter
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries of the MAC addresses table are displayed.
8.6.1.2

show mac-address-table dynamic multicast

Description
This command shows the table with the dynamic multicast MAC addresses assigned by the
device.
Note
The device does not learn any reserved multicast addresses, see also RFC 5771.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show mac-address-table dynamic multicast[vlan<vlan-range>]
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or
VLAN range
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
[address<aa:aa:aa:aa:aa:aa>]
[{interface<interface-type><interface-id>}]
Layer 2 management protocols
8.6 Multicast
Range of values / note
-
1 ... 4094
Enter the range limits with a hy‐
phen or a space.
-
-
-
Enter a valid interface.
421