Show Multicast-Block Config - Siemens SCALANCE XC-200 Configuration Manual

The parameters have the following meaning:
Parameter
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The static multicast MAC addresses are displayed.
8.6.1.4

show multicast-block config

Description
This command shows the multicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show multicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Description
Keyword for a port description
Type or speed of the interface
Module no. and port no. of the interface
Layer 2 management protocols
8.6 Multicast
Range of values / note
-
1 ... 4094
Enter the range limits with a hy‐
phen without spaces.
-
-
-
Enter a valid interface
Range of values / note
-
Enter a valid interface
423