Show Ip Nat - Siemens SCALANCE XC-200 Configuration Manual

Result
The current NAT/NAPT configuration of the interfaces is displayed.
Further notes
You enable NAT for the selected IP interface with the ip nat command in the Interface
configuration mode.
You disable NAT for the selected IP interface with the no ip nat command in the Interface
configuration mode.
You enable NAPT for the selected IP interface with the ip nat napt command in the
Interface configuration mode.
You disable NAPT for the selected IP interface with the no ip nat napt command in the
Interface configuration mode.
9.1.1.5

show ip nat

Description
This command shows address translations or active connections depending on the selected
parameter.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip nat { interface | static | translations}
The parameters have the following meaning:
Parameter
interface
static
translations
Result
The configured address translations or active connections are displayed.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Shows the configuration of the dynamic address
translations.
Shows the configuration of the static 1:1 address
translations.
Displays the active NAT connections.
Layer 3 functions
9.1 NAT
Range of values / note
-
-
-
435