Lldp - Siemens SCALANCE XC-200 Configuration Manual

Configuration
3.1 System
Further notes
You configure the duplex mode of the interface with the duplex command.
3.1.10.7

lldp

Description
With this command, you enable the sending and receipt of LLDP packets on the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
lldp{transmit|receive}
The parameters have the following meaning:
Parameter
transmit
receive
Note
Enabling both options
When you call this command, you can only select one option.
If you want to enable both options, call up the command again.
Result
Sending or receipt of LLDP packets is enabled.
Further notes
You disable the sending or receipt of LLDP packets with the no lldp command.
80
Description
The sending of LLDP packets is ena‐
bled.
The receipt of LLDP packets is enabled. Default: enabled
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
Default: enabled
Configuration Manual, 07/2017, C79000-G8976-C361-06