Ip Igmp Snooping Static-Group - Siemens SCALANCE XC-200 Configuration Manual

Commands relating to other topics that can be called in the VLAN Configuration mode can be
found in the relevant sections.
● If you exit the VLAN Configuration mode with the exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the end command, you return to the Privileged
EXEC mode.
8.2.3.1

ip igmp snooping static-group

Description
With this command, you create a static IGMP entry in the FDB.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip igmp snooping static-group <mcast_addr> ports <interface-type>
<iface_list>
The parameter has the following meaning:
Parameter
static-group
mcast_addr
ports
interface-type
iface_list
Result
The static IGMP entry has been created.
Further notes
You delete a static IGMP entry with the no ip igmp snooping static-group command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for a static entry
Value for a multicast address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Layer 2 management protocols
8.2 IGMP snooping
Range of values / note
-
Enter a valid multicast address.
-
Enter a valid interface
385