No Lldp - Siemens SCALANCE XC-200 Configuration Manual

3.1.10.8

no lldp

Description
With this command, you disable the sending or receipt of LLDP packets on the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no lldp{transmit|receive}
The parameters have the following meaning:
Parameter
transmit
receive
Note
Disabling both options
When you call this command, you can only select one option.
If you want to disable both options, call up the command again.
Result
Sending or receipt of LLDP packets is disabled.
Further notes
You enable the sending or receipt of LLDP packets with the lldp command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
the sending of LLDP packets is disabled
the receipt of LLDP packets is disabled
Configuration
3.1 System
81