No Spanning-Tree - Siemens SCALANCE XC-200 Configuration Manual

Parameter
link-type
portfast
port-priority
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
Result
The selected property is configured.
Further notes
You can reset the setting to the default with the no spanning-tree (properties) command.
You display these settings and other information with the commands that start with show
spanning tree ....
6.3.5.2

no spanning-tree

Description
With this command, you reset the various properties of the spanning tree function to the default
value:
The default values are as follows:
Parameter
cost
disable
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Connection status of the following net‐
work segment
Enables the PortFast function
Priority of the interface
Default value
if dynamic calculation of the path costs is not enabled:
● 200000 for physical interfaces
● 199999 for port channels
The spanning tree function is enabled on the interface
Network structures
6.3 Spanning Tree
Range of values / note
● point-to-point
● shared
Default:
● point-to-point
The connection is configured
as full-duplex
● shared
in all other cases
-
Default: disabled
0 ... 240 in steps of 16
Default: 128
243