Sinema; The "Show" Commands; Show Sinema; Commands In The Global Configuration Mode - Siemens SCALANCE XC-200 Configuration Manual

Configuration

3.6 SINEMA

3.6 SINEMA
3.6.1

The "show" commands

This section describes commands with which you display various settings.
3.6.1.1

show sinema

Description
This command shows whether the SINEMA configuration interface is enabled or disabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show sinema
Result
The setting of the SINEMA configuration interface is displayed.
3.6.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
120
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06