Siemens SCALANCE XC-200 Configuration Manual page 342

Network protocols
7.5 SNMP
Parameter
Seconds
retries
RetryCount
taglist
TagIdentifier
none
Storage Type
port
integer
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If optional parameters are not specified when configuring, the following defaults apply:
Parameter
taglist
Storage Type
port
Result
The SNMP target address is configured.
Further notes
You delete the SNMP target address with the no snmp targetaddr command.
You display the SNMP target address with the show snmp targetaddr command.
You configure the SNMP target parameters with the snmp targetparams command.
You display the SNMP target parameters with the show snmp targetparam command.
342
Description
Time in seconds
Keyword for the maximum number of
attempts to obtain a response to an
inform request message
Number of attempts
Keyword for tag list
Tag identifier that selects the target
address for SNMP.
No tag identifier
Specifies whether the settings re‐
main following a restart.
Keyword for the port number at which
the SNMP manager receives traps
and inform messages
Port number
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values
1 ... 1500
-
1 ... 3
-
Specify the tag identifier.
-
● volatile:
The default settings are used
after a restart.
● nonvolatile:
The saved settings are used after
a restart.
-
1 ... 65535
Default value
snmp
volatile
162
Configuration Manual, 07/2017, C79000-G8976-C361-06