D-Link DXS-3600 Series Cli Reference Manual page 82

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)#
5-15 service password encryption
This command is used to enable the encryption of the password before stored in the configuration file.
The no command will disable the encryption.
service password-encryption
no service password-encryption
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level:15.
Usage Guideline
The user account configuration information is stored in the running configuration file and can be applied to
the system later. If the service password-encryption command is enabled, the password will be stored
in the encrypted form.
When the service password encryption option is disabled and the password is specified in the plain text
form, the password will be in plain text form. However, if the password is specified in the encrypted form
or if the password has been converted to the encrypted form by the last enable password encryption
command, the password will still be in the encrypted form. It cannot be reverted back to plain text.
The password affected by this command includes the user account password, enable password, and the
authentication password.
Example
This example shows how to enable the encryption of the password before stored in the configuration file.
Switch# configure terminal
Switch(config)# service password encryption
Switch(config)#
5-16 show terminal
This command is used to obtain information about the terminal configuration parameter settings for the
current terminal line. Use this command in any EXEC mode or any configuration mode.
show terminal
Parameters
77