Basic System Configuration Commands; Clock Datetime; Basic System Configuration And Debugging - H3C s3600 series Command Manual

1

Basic System Configuration and Debugging

Commands
The configuration of real-time monitoring of the running status of the system is added. For the
detailed configuration, refer to section
The configuration of loading hot patch is added. For the detailed configuration, refer to sections
display patch-information,
The configuration of identifying and diagnosing pluggable transceivers is added. For the detailed
configuration, refer to sections
interface, display transceiver
The language-mode command is deleted.

Basic System Configuration Commands

clock datetime

Syntax
clock datetime HH:MM:SS { YYYY/MM/DD | MM/DD/YYYY }
View
User view
Parameters
HH:MM:SS: Current time, namely, hour:minute:second. HH ranges from 0 to 23, and MM and SS range
from 0 to 59.
YYYY/MM/DD or MM/DD/YYYY: Current date, where YYYY represents year ranging from 2000 to 2099,
MM represents month ranging from 1 to 12, and DD represents day ranging from 1 to 31.
Description
Use the clock datetime command to set the current date and time of the Ethernet switch.
By default, it is 23:55:00 04/01/2000 when the system starts up.
In an implementation where exact absolute time is required, it is necessary to use this command to set
the current date and time of the Ethernet switch.
After the setting, you can use the display clock command to check your configuration.
system-monitor
patch activate, patch delete,
display transceiver alarm
interface, and display transceiver manuinfo
1-1
enable.
patch load, and patch
interface, display transceiver diagnosis
interface.
run.