Display Version - H3C s3600 series Command Manual

interface-type: Interface type.
interface-number: Interface number.
module-name: Functional module name.
fabric: Specifies to display the enabled debugging of the switches in the Fabric.
by-module: Specifies to display fabric debugging by module.
Description
Use the display debugging command to display enabled debugging on a specified device or the whole
Fabric.
Examples
# Display enabled debugging on unit 1.
<Sysname> display debugging unit 1
IP icmp debugging is on
Rip packet debugging switch is on
Rip receive debugging switch is on
Rip send debugging switch is on

display version

Syntax
display version
View
Any view
Parameters
None
Description
Use the display version command to display the version information about the switch system.
Specifically, you can use this command to check the software version and release time, the basic
hardware configuration, and some other information about the switch.
Examples
# Display the version information of the system.
<Sysname> display version
H3C Comware Platform Software
Comware Software, Version 3.10, Test 1545
Copyright (c) 2004-2007 Hangzhou H3C Technologies Co., Ltd. All rights reserved.
S3600-52P-EI uptime is 0 week, 0 day, 23 hours, 15 minutes
S3600-52P-EI with 1 Processor
64M bytes DRAM
16384K bytes Flash Memory
1-7