Table of Contents
Advertisement
10
5110
8. Disconnect the rear main wiring (parking aid sensor) connector and unscrew the two mounting bolts (12 mm)
at both sides of rear bumper beam. Carefully remove the rear bumper beam assembly.
Rear Bumper Beam Bolts (LH)
Rear Bumper Beam Bolts (RH)
Tightening Torque:
Tightening torque:
42 ~ 62 Nm
42 ~ 62 Nm
Do not remove the upper bolt.
Do not remove the lower bolt.
A. Disconnect the rear main wiring (parking aid sensor) connector.
At this moment, the side fastener for the connector should be removed.
9. Install the rear bumper beam assembly in the reverse order of removal.
BODY EXTERIOR
CHANGED BY
KYRON SM - 2005.09
EFFECTIVE DATE
AFFECTED VIN
Advertisement
Chapters
Table of Contents
Troubleshooting
