Measure:vstart - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

35
Obsolete and Discontinued Commands

:MEASure:VSTArt

Command Syntax
:MEASure:VSTArt <vstart_argument>
<vstart_argument> ::= value for vertical marker 1
The :MEASure:VSTArt command moves the vertical marker (Y1 cursor) to
the specified value corresponding to the selected source. The source can
be selected by the MARKer:X1Y1source command.
The short form of this command, VSTA, does not follow the defined Long Form to Short
N O T E
Form Truncation Rules (see
both VSTArt and VSTOp, so sending VST for the VSTArt command produces an error.
The :MEASure:VSTArt command is an obsolete command provided for compatibility to
N O T E
previous oscilloscopes. Use the :MARKer:Y1Position command (see
Query Syntax
:MEASure:VSTArt?
The :MEASure:VSTArt? query returns the current value of the Y1 cursor.
Return Format
<value><NL>
<value> ::= voltage at voltage marker 1 in NR3 format
See Also
•
•
•
•
•
•
•
•
•
1078
(see page 1138)
"Introduction to :MARKer Commands"
"Introduction to :MEASure Commands"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta" on page 391
":MARKer:X1Y1source"
":MEASure:SOURce"
":MEASure:TDELta" on page 1068
":MEASure:TSTArt" on page 1072
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
page 1140). The normal short form, VST, would be the same for
on page 380
on page 406
on page 389
on page 390
on page 383
on page 444
page 389) instead.